To create a 50x40mm wargame base with a slot for a 5mm D6 die, you can follow these steps: 1. **Materials needed:** - A piece of plasticard or any suitable material to make the base. - A craft knife or scissors to cut the plasticard. - Sandpaper or a file to smooth the edges. - A ruler and pencil for measuring and marking. - Super glue or similar adhesive. 2. **Measure and mark the dimensions**: - Use a ruler to measure out a rectangular shape with dimensions of 50x40mm on the plasticard. - Mark the corners using a pencil. - Double-check your measurements to ensure accuracy. 3. **Cut out the base shape**: - Carefully cut along the marked lines using a craft knife or scissors. - Take your time to ensure clean and precise cuts. - Smooth any rough edges using sandpaper or a file. 4. **Create the slot for the die**: - Measure the diameter of the D6 die (which is 5mm in this case) with a ruler. - Mark the center point of one of the long sides of the base (40mm side). - Using the measured diameter as a guide, draw a straight line across the width of the base at the center point. - Repeat the measurement and marking on the other long side of the base. 5. **Cut the slot**: - With the craft knife or scissors, carefully cut along the marked lines to create a narrow slot through the width of the base. - The slot should be slightly wider than the diameter of the die to allow it to fit snugly. 6. **Test the fit and adjust if needed**: - Check if the D6 die fits into the slot comfortably without being too loose or too tight. - If necessary, widen the slot slightly for a better fit using a file or sandpaper. 7. **Attach miniatures to the base**: - Once you are satisfied with the base and slot, you can glue your miniatures or models onto the base using super glue or a suitable adhesive. - Ensure that the glue is dry before moving or using the base. Remember to exercise caution when using sharp tools, and work in a well-ventilated area if using any adhesives. Enjoy your wargaming!